Optional Accessories

This is an attachment which can be placed on the scissor lift in order to move the unit. The handle is removable. This option only allows the lift to be moved without a load on it.

Wheels and a power drive mechanism are added to the scissor lift table.

Featuring all stainless steel panel construction, stainless steel hardware and piano hinge cover. Often used in exterior or wash down applications.

For applications where recurring equipment damage is a concern. Heavy skirting is provided down from the platform sides.

WIde loads can be handled by increasing the width of the lift platform or base.

The entire lift or components of the lift can be constructed from stainless steel.

Can be either side installed or installed under frame, providing easy portability.

Use to accommodate wheeled traffic onto or off of the lift.

Allows for unskidded loads to be placed on the top and the forks of the fork lift removed.

Two tables can be physically joined by a common platform and base.

To accommodate wall mounting of a hydraulic power unit.

Installed so that the beam protects the front edge of platform as it lowers to the floor. Stops downward movement of lift if any object obstructs the beam. No Low ONLY.

Control station contained in a NEMA12 rated metal enclosure and mounted to an adjacent wall.

Rings for 1 to 6 seconds before up or down functions commence.

A longer fork length - built to specific application requirements.
Bin Tilter ONLY.

A lock that creates friction on the floor to prevent movement of the  bin tilter. Bin Tilter ONLY.

Wider fork spacing - built to specific application requirements.
Bin Tilter ONLY.

Used with air motor power units to filter and regulate the pressure of the supplied air. ProAir ONLY.

For special applications where it is desirable to eliminate electrical power supply.  An air motor replaces the electric motor on the hydraulic power unit. The air consumption requirements to accommodate this option are relatively high. The cost of this option is considerable.

Offers quicker cycle times for air motor power units. ProAir ONLY.

Available in many widths and can be interlocked, preventing lift table from lifting or lowering if gate is not latched.

Precise stopping at any position without over-run.

Alternative to accordion bellows, to minimize debris entry under platform. Often used in 1-2-3 sided applications..

Suited to high cycling applications.

Improves applications such as conveyor systems, directional transfer or high capacity handling.

Lift table can be manually moved with load, but may not be practical if towing powered equipment. Consult factory. Both fixed and swivel casters are available in several styles. Mounting can be beneath the base frame or outboard.

Load cells are added to facilitate weighing of product on lift.

Maximum tilt is set at 40 degrees.
Tilter ONLY.

Maximum tilt is set at 30 degrees.
Tilter ONLY.

A stand that the tilter is installed onto to raise its operating position.
Tilter ONLY.

An integral maintenance stand is provided with the lift. Tilter ONLY.

For a tilter, nonstandard heights are available for the back stop.
Tilter ONLY.

A circular shaped rotating platform. Similar in function to a “lazy Suzanne”.

Additional hydraulic hose to the standard of 10ft of hose.

The power supply voltages available include 115 and 220 volt single phase. 230, 460 and 600 volt 3 phase.  380 3 phase 50 hertz voltage is also available. 3 phase voltages are recommended where possible to avoid any line loss issues.

Low height refers to the dimension from the bottom of the frame to the top of the platform when the lift table is in the fully lowered position.