Covering Material Covering material is available in 22 oz. vinyl, 32 oz. vinyl, 40 oz. vinyl and Pentalon 1.
Available Model: PS100, PS200, PS700
Side Pad Projection Extra side pad projection is available to provide 4”- 6” of projection beyond the face of the dock bumper. 4”- 6” of projection beyond the face of the dock bumper provides the correct amount of compression to ensure a good seal.
Available Model: PS100, PS200, PS700
Side Pad Height Extra side pad height is available to suit higher than standard overhead doors.
Available Model: PS100, PS200, PS700
Head Pad Width (over 120”) Extra head pad width is available to suit wider than standard overhead doors.
Available Model: PS100
Head Pad Drop Curtain Foam head pad equipped with a 6” drop curtain to seal the top of a lower truck body in position at the loading dock. Also available with Velcro strips to hold up and out of the way when curtain not required.
Available Model: PS100
Beveled Head Pad Face of head pad is higher than the back of the head pad. Closes door height opening without the back of the head pad infringing downward into the top of door opening leading to accidental back board impact.
Available Model: PS100
Head Curtain Width (over 120”) Extra head curtain width is available to suit wider than standard overhead doors.
Available Model: PS200
Reinforced inside Face of Side Pads (up to 48” high) Reinforced covering material on the inside face of the side pads is available to protect against accidental abrasive scuffing contact when loading “side by side” product on the rear of the truck.
Available Model: PS100, PS200
Galvanized Backing The back of the wooden frame that contacts the building wall is covered in galvanized steel to prolong the life of the dock seal.
Available Model: PS100, PS200, PS700
Build Out Box Used to project the dock seal forward when the overall dock seal projection required exceeds the maximum allowable foam projection.
Available Model: PS100, PS200, PS700
Double Face Layer Additional layer of covering material installed over the primary layer of covering material to provide extra abrasion protection.
Available Model: PS100, PS200
Rain Stop Seal Full width, covered foam head pad seal that pushes down on top of the truck body. This positive top seal diverts the rain from running off the top of the truck body down onto the loading dock by creating a positive rain seal.
Available Model: PS100, PS200
Beveled Side Pads Face of side pad is wider than the back of the side pad. Closes door width opening without the back of the side pads infringing on door width opening leading to accidental back board impact.
Available Model: PS100, PS200
Tapered Side Pads Side pads tapered to suit declining approach at loading dock. Side pads project more at the bottom than at the top to ensure an even side pad compression with the truck in position.
Available Model: PS100, PS200
Wear Pleats Installed on the face of the side pads, designed to “flex” up and down with a truck in position during loading to minimize abrasion to side pad covering material.
Available Model: PS100, PS200